These instructions are for the Remote portion only. Using these programming instructions will not allow your key to start your vehicle only Lock, Unlock, and open trunk.
Key portion must be cut and programmed by a professional locksmith or the dealership.
Obtain all remote transmitters for this vehicle. Must have One original master key for these to work.
1. Start with the key out of the ignition, drivers door is open,
all other doors and trunk closed and drivers door is unlocked.
2. Perform these steps within 5 seconds. A. Insert the key into the ignition
(Do NOT Turn it) and Pull key out. B. Insert the key into the ignition (Do NOT
Turn it) and Pull key out.
3. Perform these steps within 40 seconds. A. Close then open the drivers door.
B. Close then open the drivers door. C. Insert the key into the ignition (Do
NOT Turn it) and Pull key out.
4. Perform these steps within 40 seconds. A. Close then open the drivers door.
B. Close then open the drivers door. C. Insert the key into ignition and leave
it in the ignition. D. Close the drivers door. E. Turn the ignition to ON (Do
NOT Start or crank engine) then back to OFF. F. Remove the key from the
ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically
indicating successful entry into programming mode. Return to step 1 if the door
locks do not cycle at this point.
6. Perform these steps within 40 seconds. A. Press the lock and unlock buttons
on the remote simultaneously for 1.5 seconds. B. Immediately after letting go
of the lock and unlock buttons, Press the lock button by itself and hold for 2
seconds. Within 3 seconds, the door locks should lock and then unlock once
indicating successful programming. If the door locks cycle twice, repeat steps
A and B in step 6 as the remote was not accepted. C. Repeat steps A and B in
step 6 for each new remote.
7. Open drivers door.
