THIS IS A BRAND NEW REMOTE. ALL OF OUR ITEMS HAVE BEEN TESTED AND WE OFFER A 100% MONEY BACK GUARANTEE, SO PURCHASE WITH CONFIDENCE AND NO RISK!
VEHICLE: 2002 Toyota Sequoia PROGRAMMING INSTRUCTIONS: GOOD NEWS! THIS REMOTES IS SELF-PROGRAMMABLE, NO PROFESSIONAL NEEDED. PLEASE SEE BELOW FOR COMPLETE PROGRAMMING INSTRUCTIONS KEY FOB INCLUDES NEW BATTERY WE HAVE PHONE SUPPORT: 402-964-2720
This is a Brand New Keyless Entry Remote KEY FOB for a 2002 Toyota Sequoia. This Key FOB fits many other vehicles, please see listing for list of compatible vehicles. We ship United State Postal Service First Class mail and have items shipped within 1 business day. Please email with questions. 100% Money Back Guarantee!
PROGRAMMING INSTRUCTIONS FOR 2002 Toyota Sequoia
1. Start with key out of ignition, drivers door is open all others closed and
drivers door is unlocked.
2. Insert key into the ignition (Do NOT Turn) and Pull key out.
3. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Close, then open drivers door.
4. Perform these steps within 40 seconds.
A. Using the power lock switch on the drivers door, perform 5 lock/unlock cycles
starting with lock. Use an even pace and try to go about one cycle per second.
(1Cycle = 1 lock and 1 unlock).
B. Insert the key in the ignition cylinder.
C. Turn the ignition to ON (Do NOT Start) then back to OFF once to program remote
while retaining the orginal remote codes. Twice to erase all orginal codes and
add new remote. Three times to check how many remotes are programmed or
five times to erase all original codes.
D. Remove the key from the ignition.
5. Within 3 seconds the power door locks should cycle automatically indicating successful
entry into programming mode. Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remote simultaneously for 1 second.
B. Immediately after letting go of the lock and unlock buttons, press the lock button by
itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle once
indicating successful programming. If the door locks do not cycle, or cycle twice.
repeat steps A and B in step 6 as your remote has not been accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Close drivers door.
| 
