Obtain all remote transmitters for this vehicle.
1. Start with the key out of the ignition, driver�s door is
open, all other doors and trunk closed and driver�s door is unlocked.
2. Perform these steps within 5 seconds.
A. Insert the key into the ignition
(Do NOT Turn it) and Pull key out.
B. Insert the key into the ignition
(Do NOT Turn it) and Pull key out.
3. Perform these steps within 40 seconds.
A. Close, then open the driver�s
door.
B. Close, then open the driver�s
door.
C. Insert the key into the ignition
(Do NOT Turn it) and Pull key out.
4. Perform these steps within 40 seconds.
A. Close, then open the driver�s
door.
B. Close, then open the driver�s door.
C. Insert the key into ignition and
leave it in the ignition.
D. Close the driver�s door.
E. Turn the ignition to ON (Do NOT
Start or crank engine) then back to OFF.
F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then
unlock automatically indicating successful entry into programming mode. Return to step 1 if the door locks do not
cycle at this point.
6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons
on the remote simultaneously for 1.5 seconds.
B. Immediately after letting go of
the lock and unlock buttons, Press the lock button by itself and hold for 2
seconds. Within 3 seconds, the door
locks should lock and then unlock once indicating successful programming. If the door locks cycle twice, repeat steps A
and B in step 6 as the remote was not accepted.
C. Repeat steps A and B in step 6 for each new
remote.
7. Open driver�s door.
perfect! 
