Obtain all
remote transmitters for this vehicle.
You must
have Two working keys (keys that start your car) to perform this procedure.
1. Cut the new
key to match existing keys.
2. Insert
the first valid key into the ignition switch. Turn the ignition switch to the
ON position for at least three seconds, but no longer than 15 seconds. Then,
turn the ignition switch to the LOCK position and remove the first key.
3. Insert
the second valid key into the ignition switch. Turn the ignition switch to the
ON position within 15 seconds. After 10 seconds, a chime will sound. In
addition, the vehicle security light will begin to flash. Turn the ignition
switch to the LOCK position and remove the second key.
4. Insert a
blank key into the ignition switch. Turn the ignition switch to the ON position
within 60 seconds. After 10 seconds a single chime will sound. In addition, the
vehicle security light will stop flashing. To indicate that programming is
complete, the vehicle Security light will turn on again for three seconds and
then turn off.
5. The new
key is now programmed. The remote Keyless Entry transmitter will also be
programmed during this procedure.
6. Repeat
this procedure to program up to eight keys.
Please refer
to your owner�s manual if you are uncertain of the location of Lock and or On.
Quality key and programming instructions 
