PROCEDURE
#1
THIS PROCEDURE IS FOR VEHICLES WITH THE DRIVER INFORMATION
CENTER. IT WILL BE A BUTTON TO THE RIGHT OF THE STEERING WHEEL WITH A VEHICLE
ICON AND THE LETTER i.
1.
Insert key and switch the ignition ON (just shy of starting vehicle without
cranking engine)
2.
Press vehicle information button until PRESS TO RELEARN REMOTE KEY is
displayed.
3.
Press the set/reset button (button will have a checkmark) until REMOTE KEY
LEARNING ACTIVE is displayed. Vehicle is now in programming mode.
4.
Press and hold LOCK and UNLOCK buttons at the same time on first remote for
approximately 15 seconds. An acoustic signal will be heard indicating
successful programming.
5.
Repeat step 4. to program additional remotes. You can have up to 8 programmed
remotes for this vehicle. You must program ALL remotes including existing
remotes.
6. To
exit programming mode turn ignition OFF, remove key and test all remotes.
PROCEDURE
#2
THIS PROCEDURE IS FOR VEHICLES WITHOUT THE DRIVERS INFORMATION
CENTER.
1.
Insert key into the ignition and turn to ON (Just shy of starting vehicle
without cranking engine).
2.
Press the trip odometer reset button until RELEARN REMOTE KEY is displayed.
3.
Press and hold the trip odometer reset button for approximately 3 seconds until
REMOTE KEY LEARNING ACTIVE displays.
4.
Press and hold LOCK and UNLOCK buttons at the same time on first remote for
approximately 15 seconds. An acoustic signal will be heard indicating successful
programming.
5.
Repeat step 4. to program additional remotes. You can have up to 8 programmed
remotes for this vehicle. You must program ALL remotes including existing
remotes.
6. To
exit programming mode turn ignition OFF, remove key and test all remotes.