You Must have Two Working Transponder Keys (keys that start
your car) to perform this procedure. If you only have one working key or none
at all it must be programmed by a dealer or locksmith.
1. Insert an existing (working) key into the ignition
cylinder.
2. Turn the ignition cylinder ON (Position 3) and back to
OFF (Position 1). Ignition should stay in ON position for at least three seconds
but no more than ten seconds.
3. Remove the existing key and WITHIN TEN SECONDS, insert a
second working key and turn to ON and then back to OFF. Ignition should stay in
ON position for at least three seconds but no more than ten seconds.
4. Remove the second key, insert the New (unprogrammed) key
before twenty seconds have elapsed and turn to ON. Leave it in the ON position
for at least six seconds and turn back to OFF.
5. If the new key has been successfully programmed it will
start the vehicle and operate the remote keyless entry system. The theft
indicator light will light up for three seconds to indicate the key was
successfully programmed.
If the new key was not successfully programmed, repeat steps
1-4. If the remote portion of the remote did not program but the key will start
the vehicle, then please perform the procedure below to program the remote
portion of your remote head key
Remote Portion of Key Fob (Only if the above procedure didn?t program
the remote)
Obtain all remote transmitters for this vehicle. It's not
necessary to re-program your working remote head keys as those will continue to
work. If you are programming additional non-remote head key remotes for your
vehicle then they must all be programmed during this procedure. You are able to
program up to four remotes in addition to your remote head keys.
Do not depress the brake pedal during procedure.
1. Turn
ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in
RUN. Door locks will cycle to confirm programming mode. (Off is the position
where you can remove your key, RUN is the position just shy of starting your
car.)
2. Within
20 seconds press any button on the first keyless remote to be programmed. Door
locks will cycle to confirm programming. If you only have one remote then skip
to step 4.
3. Within
20 seconds, press any button on the second keyless remote. Door locks will
cycle again to confirm programming. Repeat step 3. for all other remotes.
4. Turn
ignition to OFF. Locks will again cycle to indicate end of programming mode.
Key will not work with my car 
