Bring your 2009 Chevrolet Traverse out of the dark ages and back into the modern era!Key fob, car remote, clicker thingy, key bob... We've heard it called just about everything under the sun. No matter what you call it, one thing is certain: life is just a little bit sweeter when you can lock and unlock your car with the push of a button. Let's face it, it's the 21st Century and no one has time to fumble with caveman technology trying to stick a key into a lock to get into their car. Once you receive your new key fob simply program it to your vehicle and you'll be sliding in and out of your car with ease just like the rest of the cool kids.
Questions?
This remote is self programmable. 2010 + and above vehicles will require dealer or locksmith programmingPROCEDURE #1THIS PROCEDURE IS FOR VEHICLES WITH THE DRIVER INFORMATION CENTER. IT WILL BE A BUTTON TO THE RIGHT OF THE STEERING WHEEL WITH A VEHICLE ICON AND THE LETTER i.1.Insert key and switch the ignition ON (just shy of starting vehicle without cranking engine)2. Press vehicle information button until PRESS TO RELEARN REMOTE KEY is displayed.3. Press the set/reset button (button will have a checkmark) until REMOTE KEY LEARNING ACTIVE is displayed. Vehicle is now in programming mode.4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will be heard indicating successful programming.5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.6. To exit programming mode turn ignition OFF, remove key and test all remotes.PROCEDURE #2THIS PROCEDURE IS FOR VEHICLES WITHOUT THE DRIVERS INFORMATION CENTER.1. Insert key into the ignition and turn to ON (Just shy of starting vehicle without cranking engine).2. Press the trip odometer reset button until RELEARN REMOTE KEY is displayed.3. Press and hold the trip odometer reset button for approximately 3 seconds until REMOTE KEY LEARNING ACTIVE displays.4. Press and hold LOCK and UNLOCK buttons at the same time on first remote for approximately 15 seconds. An acoustic signal will be heard indicating successful programming.5. Repeat step 4. to program additional remotes. You can have up to 8 programmed remotes for this vehicle. You must program ALL remotes including existing remotes.6. To exit programming mode turn ignition OFF, remove key and test all remotes.
